primary pulp on 3d graphic

[hazmat]

Is there a way to show on the chart a pulpotomy for primary teeth? I changed the procedure code paint type to RCT and buildup but neither one will show on primary teeth. Works fine on permanent teeth.

On a similar note, is it possible to change the treatment plan color for some procedures? For example, I do some sealants with air abrasion and some without. There is a different code for both. They both show the same on the graphical chart however. It would be nice if you could visually see the plan rather than looking at the code in the progress notes.

Thanks, Joe

[jordansparks]

Can't show a pulpotomy for a primary tooth graphically yet.

Changing treatment plan color by individual procedure code is also not yet a feature.

[fdscadmin]

Bump....

I think this would be an awesome feature along with graphically showing a space maintainer. Is this even on the radar right now?

[jordansparks]

Pulpotomies can show now in version 6.9. Is that what you were asking about?

[Baltar]

Bump....

I think this would be an awesome feature along with graphically showing a space maintainer. Is this even on the radar right now?

I use the draw feature to indicate pulps and Band & Loop. it is a pain though....

[fdscadmin]

Yes, perfect. (Pulps) For the space maint, I'll try the drawing method for now.