Page 1 of 1
Edit procedure code
Posted: Wed Nov 19, 2008 6:09 am
by fishdrzig
In the edit procedure code section, can a time be set to zero so, for example if a code of Periodic exam 15min, child prophy 15min, child flo=zero minutes. This way any child pro visit can be kept to 30min by default?
Re: Edit procedure code
Posted: Wed Nov 19, 2008 6:34 am
by drtech
just put the assistant time down as one / and it won't add
Re: Edit procedure code
Posted: Wed Nov 19, 2008 7:16 am
by fishdrzig
I am assuming that there is a setup somewhere to make /=zero because I think the program defaults to 10min even with one /
Re: Edit procedure code
Posted: Wed Nov 19, 2008 7:49 am
by jordansparks
There is an explanation of time calculations on this page:
http://www.open-dent.com/manual/aptedit.html
Re: Edit procedure code
Posted: Thu Nov 20, 2008 2:14 am
by fishdrzig
On the "Time locked" box that can be checked, is it patient specific or not. I mean if I want one patient to have a 60min pro and another 45 min, if I check the box will it stay that way for that particular patient.
Is there anyway to may time = zero for a procedure, or does it always default to 10min?
Re: Edit procedure code
Posted: Thu Nov 20, 2008 8:07 pm
by jordansparks
The time will only be locked for that appointment.
Re: Edit procedure code
Posted: Fri Nov 21, 2008 5:12 pm
by drtech
Is there anyway to may time = zero for a procedure, or does it always default to 10min?
if you set it one / on these procedures it will equal zero time when combining with any other procedure, and then 10/15min if by itself.