F & V surfaces
Posted: Wed Sep 21, 2011 8:31 am
Jordan...
If you chart a treatment plan item with both the 'F" and "V" surfaces OD doesn't recognize that they are the same surface and gives a warning asking if you want to use a two surface restoration instead.
In the grand scheme of things it barely registers on my radar as an annoyance since the work around is just one click but still though I would point it out.
If you chart a treatment plan item with both the 'F" and "V" surfaces OD doesn't recognize that they are the same surface and gives a warning asking if you want to use a two surface restoration instead.
In the grand scheme of things it barely registers on my radar as an annoyance since the work around is just one click but still though I would point it out.