Open Dental Forum

Hi folks,

I am trying to work with an intraoral x-ray sensor: a planmeca Dixi3 sensor, attached to a Network Interface box. So far, I have been able to connect the sensor to the Network Interface box, and access boxe's web UI: i.e. able to change the IP address of the box and the port number.

I also configured my PC with the box's IP address and port, i.e. I ran the Didapi config exe and set it up.

Now I am stumped! I can not for the life of me, figure out how to get Apteryx to see this sensor. I think I need the Planmeca twain driver, i.e. get the sensor to show up on PC as a device.

Any idea where I can get the Twain driver for Planmeca? Appreciate any help & advice!
TIA,
Manu

https://pattersonsupport.custhelp.com/a ... /related/1

Try that!



http://patterson.eaglesoft.net/smilegoo ... CD_465.zip

Have to hand it to them... they document a lot of stuff.

Thank you very much Justin! With your help, I did manage to get it to work.