Treatment area required for dentures to paint chart
Posted: Wed Dec 30, 2015 5:30 am
When adding a complete denture to the treatment plan, it will only paint the graphical chart if the procedure code has the treatment area of arch selected AND the user has an arch selected. However, this means that every time you treatment plan a denture, the procedure info box pops up to prompt for the arch (unless you select a tooth before adding it).
It seems that since there is a separate code for max vs mand, there should be no need to specify the arch for this code, and that the treatment area could be set to mouth, eliminating this popup. This works, however, it no longer paints anything on the chart. Is there a way to eliminate the popup prompting for the arch or the need to select a tooth prior to adding the code? Or perhaps to set a default treatment area via the procedure list, autocodes, or procedure buttons? Maybe this has been fixed in future versions. Thanks!
We are running 14.1.14.0.
It seems that since there is a separate code for max vs mand, there should be no need to specify the arch for this code, and that the treatment area could be set to mouth, eliminating this popup. This works, however, it no longer paints anything on the chart. Is there a way to eliminate the popup prompting for the arch or the need to select a tooth prior to adding the code? Or perhaps to set a default treatment area via the procedure list, autocodes, or procedure buttons? Maybe this has been fixed in future versions. Thanks!
We are running 14.1.14.0.